车库门的常见故障及解决方法

Common malfunction and solution of garage door

用手动开关或遥控器不能启动驱动装置

Manual switch or remote control can not start the driving device.

·驱动装置没有接通电源

The driving device does not turn on the power supply

·手动开关或遥控接收板断路

Manual switch or remote control receiving board circuit breakage

·运行次数过多导致电机热保护

Thermal protection of motor caused by too many times of operation

·检查插座、插头、手动开关、保险管熔丝

Checking sockets, plugs, manual switches and fuse tubes.

·检查手动开关及遥控接收板接线

Check the manual switch and the remote control receiving board connection

·重新定位行程开关以增加行程门关不严或开不完全

Repositioning the travel switch to increase the number of travel doors is not strict or not fully open.

·行程开关位置调节不准确

The position adjustment of the stroke switch is inaccurate

·重新定位行程开关以增加行程手动开关能控制驱动装置而遥控器不能

Repositioning the stroke switch to increase the stroke, manual switch can control the driving device, and the remote control can not.

·遥控器未对码

The remote controller is not on the code

·遥控系统故障

The malfunction of the remote control system

·按照仿单指导完成对码操纵

Finish the code manipulation according to the copy guidance

·更换遥控器内部电池

Replace the battery inside the remote control

·请维修职员检查接收控制板门未关紧就自动反向运行或开门时未接触行程开关就半途休止运行

Please check the receiving control panel when the door is not closed, automatically reverse operation or open the door when the non contact travel switch halfway operation.

·开关门阻力大于设置启闭负载力激活了障碍感应系统

The resistance of the switch door is larger than that of the opening and closing load force, which activates the obstacle induction system.

·连杆长度调节不当

Improper adjustment of connecting rod length

·拉开离合装置，检修门体与扭簧是否平衡、启闭是否灵活

Open the clutch device, check whether the door body is in balance with the torsion spring, and whether the opening and closing is flexible.

·增大开闭负载力

Increase the loading force of opening and closing

·在门封闭时调节连杆长度门体单向运行

Adjust the length of the connecting rod when the door is closed.

·行程开关损坏或行程开关线短路

Stroke switch damage or stroke switch line short circuit

·光电开关光路上有障碍物

Photoelectric switch on the road with obstacles

·启闭负载力调节没有到位

The adjustment of load capacity of opening and closing is not in place

·检查行程开关及行程开关接线

Check the connection of the stroke switch and the stroke switch

·清除光电外形光路上的障碍物

Removal of obstacles in the optoelectronic optical path

·重新调节启闭负载力 门体冲过行程开关

Re adjust the opening and closing load force, gate body overshoot stroke switch.

·行程开关损坏或行程开关线断路

Stroke switch damage or trip switch line circuit breakage

·检查行程开关及行程开关接线车库外遥控器作用间隔显著低于10米

Checking the travel switch and the travel switch connection, the distance between the external controls of the garage and the remote controller is significantly less than 10 meters.

·车库屏蔽严峻

The garage is stern

·电池电力不足

Insufficient battery power

·将天线延长至车库外部

Extend the antenna to the outside of the garage

·将天线伸出驱动器外部并拉直

The antenna is extended outside the drive and straightened

·更换电池门体运行噪音过大

Changing the noise of the battery door is too loud

·五金件安装不牢固

Hardware installation is not firm

·驱动装置拉杆没有位于门体中央线上

The drive rod is not located on the center line of the door

·门体运行导轨不平行

The running guide rail of the door body is not parallel

·合页、滚轮处没有涂覆润滑油

Uncoated lubricating oil at the hinge and roller

·坚固五金件

Solid hardware

·调节驱动装置拉杆与门体中央线重合

Adjusting drive device and reclosing of the central line of the door body

·调节门体运行导轨相互平行

Adjust the running guideway of the gate body parallel to each other

·在合页、滚轮处覆润滑油 驱动装置正常运行，但门体不运行

. the lubrication device is running normally on the hinge and roller, but the door is not running.

·滑架上的离合器没有复位

The clutch on the slide is not reset

·启闭负载力调节没有到位

The adjustment of load capacity of opening and closing is not in place

·复位离合器

Reset clutch

·重新调节启闭负载力。

Adjust the load force of the opening and closing.